Abstract: There are many works in color that assume illumination change can be modeled by multiplying sensor responses by individual scaling factors. The early research in this area is sometimes grouped under the heading “von Kries adaptation”: the scaling factors are applied to the cone responses. In more recent studies, both in psychophysics and in computational analysis, it has been proposed that scaling factors should be applied to linear combinations of the cones that have narrower support: they should be applied to the so-called “sharp sensors.” In this paper, we generalize the computational approach to spectral sharpening in three important ways. First, we introduce spherical sampling as a tool that allows us to enumerate in a principled way all linear combinations of the cones. This allows us to, second, find the optimal sharp sensors that minimize a variety of error measures including CIE Delta E (previous work on spectral sharpening minimized RMS) and color ratio stability. Lastly, we extend the spherical sampling paradigm to the multispectral case. Here the objective is to model the interaction of light and surface in terms of color signal spectra. Spherical sampling is shown to improve on the state of the art.

Abstract: Extraction of spatio-chromatic features from color images is usually performed independently on each color channel. Usual 3D color spaces, such as RGB, present a high inter-channel correlation for natural images. This correlation can be reduced using color-opponent representations, but the spatial structure of regions with small color differences is not fully captured in two generic Red-Green and Blue-Yellow channels. To overcome these problems, we propose a new color coding that is adapted to the specific content of each image. Our proposal is based on two steps: (a) setting the number of channels to the number of distinctive colors we find in each image (avoiding the problem of channel correlation), and (b) building a channel representation that maximizes contrast differences within each color channel (avoiding the problem of low local contrast). We call this approach more-than-three color coding (MTT) to enhance the fact that the number of channels is adapted to the image content. The higher color complexity an image has, the more channels can be used to represent it. Here we select distinctive colors as the most predominant in the image, which we call color pivots, and we build the new color coding using these color pivots as a basis. To evaluate the proposed approach we measure its efficiency in an image categorization task. We show how a generic descriptor improves its performance at the description level when applied on the MTT coding.

Abstract: Color induction is the influence of the surrounding color (inducer) on the perceived color of a central region. There are two different types of color induction: color contrast (the color of the central region shifts away from that of the inducer) and color assimilation (the color shifts towards the color of the inducer). Several studies on these effects have used uniform and striped surrounds, reporting color contrast and color assimilation, respectively. Other authors [J. Vis. 12(1), 22 (2012) [CrossRef] ] have studied color induction using flashed uniform surrounds, reporting that the contrast is higher for shorter flash duration. Extending their study, we present new psychophysical results using both flashed and static (i.e., non-flashed) equiluminant stimuli for both striped and uniform surrounds. Similarly to them, for uniform surround stimuli we observed color contrast, but we did not obtain the maximum contrast for the shortest (10 ms) flashed stimuli, but for 40 ms. We only observed this maximum contrast for red, green, and lime inducers, while for a purple inducer we obtained an asymptotic profile along the flash duration. For striped stimuli, we observed color assimilation only for the static (infinite flash duration) red–green surround inducers (red first inducer, green second inducer). For the other inducers’ configurations, we observed color contrast or no induction. Since other studies showed that non-equiluminant striped static stimuli induce color assimilation, our results also suggest that luminance differences could be a key factor to induce it.

Abstract: In this work, we propose a convolutional neural network based approach to estimate the spectral reflectance of a surface and spectral power distribution of light from a single RGB image of a V-shaped surface. Interreflections happening in a concave surface lead to gradients of RGB values over its area. These gradients carry a lot of information concerning the physical properties of the surface and the illuminant. Our network is trained with only simulated data constructed using a physics-based interreflection model. Coupling interreflection effects with deep learning helps to retrieve the spectral reflectance under an unknown light and to estimate spectral power distribution of this light as well. In addition, it is more robust to the presence of image noise than classical approaches. Our results show that the proposed approach outperforms state-of-the-art learning-based approaches on simulated data. In addition, it gives better results on real data compared to other interreflection-based approaches.

Abstract: A main weakness of virtual bronchoscopic navigation (VBN) is unsuccessful segmentation of distal branches approaching peripheral pulmonary nodules (PPN). CT scan acquisition protocol is pivotal for segmentation covering the utmost periphery. We hypothesize that application of continuous positive airway pressure (CPAP) during CT acquisition could improve visualization and segmentation of peripheral bronchi. The purpose of the present pilot study is to compare quality of segmentations under 4 CT acquisition modes: inspiration (INSP), expiration (EXP) and both with CPAP (INSP-CPAP and EXP-CPAP).

Abstract: 36.307
Many everyday behavioural uses of color vision depend on color naming ability, which is neither measured nor predicted by most standardized tests of color vision, for either normal or anomalous color vision. Here we demonstrate a new method to quantify color naming ability by deriving a compact computational description of individual 3D color spaces. Methods: Individual observers underwent standardized color vision diagnostic tests (including anomaloscope testing) and a series of custom-made color naming tasks using 500 distinct color samples, either CRT stimuli (“light”-based) or Munsell chips (“surface”-based), with both forced- and free-choice color naming paradigms. For each subject, we defined his/her color solid as the set of 3D convex hulls computed for each basic color category from the relevant collection of categorised points in perceptually uniform CIELAB space. From the parameters of the convex hulls, we derived several indices to characterise the 3D structure of the color solid and its inter-individual variations. Using a reference group of 25 normal trichromats (NT), we defined the degree of normality for the shape, location and overlap of each color region, and the extent of “light”-“surface” agreement. Results: Certain features of color perception emerge from analysis of the average NT color solid, e.g.: (1) the white category is slightly shifted towards blue; and (2) the variability in category border location across NT subjects is asymmetric across color space, with least variability in the blue/green region. Comparisons between individual and average NT indices reveal specific naming “deficits”, e.g.: (1) Category volumes for white, green, brown and grey are expanded for anomalous trichromats and dichromats; and (2) the focal structure of color space is disrupted more in protanopia than other forms of anomalous color vision. The indices both capture the structure of subjective color spaces and allow us to quantify inter-individual differences in color naming ability.